Brick pavers can be mounted to create a multitude of patterns and colors, all chosen by the DIY’er. At home centers and masonry suppliers today, there are just tons of brick paver sizes, shapes, and colours. Make sure you take the time to visit several sellers before the final products for your walkways are picked. It’s not very difficult to install a paver walkway but it does require a lot of manual labor. If the walkway is not directly adjacent to an area where the pallets can be placed upon delivery, then the amount of labor increases as you have to move the pavers to the actual work area over a distance. This is the work area where friends can be of great help.Get the facts about Paver Installation near me you can try this out.
Start your project with the walkway laying out itself. A garden hose is an excellent construction device if there are curves to the new walkway. Layout the hose as close to the shape as you wish, and then fine-tune it until it is accurate. Mark the position of the hose using standard lawn lime and a paper cup and this will be one side of the new walk. Wash the hose from your hands and make sure you wash the lime. It’s great for lawns, and environmentally friendly. A handy tool you’ll use over and over is to cut a two by four, six inches longer than the width of your walkway. During construction, it can be used to ensure that you have planned a sufficiently large area for the pavers, and then as a screed board to level the base sand under the pavers. Now remove from the walkway area the dirt, gravel , sand, etc. plus at least three inches on either side. The walkway should be excavated at least two inches deeper than the width of the paver blocks. If you want the stones to be flush with the adjacent lawn or driveway, measure the thickness of the stones and add two inches to that depth and excavate.
Once the excavation is complete, at least two inches of stone dust or concrete sand will be placed at the bottom of the excavation. Using your two by four screed boards and a level of carpenters, level the sand keeping it slightly higher than the finished product you want. Once the sand is in place a mechanical tamper powered by gasoline must be used to compact the sand thoroughly. Keep in mind that when compacted the sand will settle and additional material may need to be added across the walk to reach the final compacted height finished. If you do this job, you want to be really mean. The final surface of the walkway will represent any flaws that you left behind in the way of dips or bumps in the sand. Make sure the compacted sand / dust on each side is at least three inches wider than the finished width of the walkway.
Using a string line to keep one side of the walk in place is always a good idea. If one side is straight then the other side follows. Start laying your stones on paver in whatever pattern you choose. Straight line, lap bond, diagonal, herringbone, or whatever pattern you might think is ok. Run around the whole width of the walk and if you have a partner using a wet saw, cutting and positioning some smaller bits will speed up the job considerably. As you complete an field, install a retainer strip with plastic brick edge along with the supplied ground nails or stakes. Keep the retainer as close as possible against the pavers, force the ground nails into the ground to hold the retainer strip in place. That prevents the pavers from moving sideways. Continue with installing the paver until all the pavers are installed.
Cast this material over the top of all the pavers using whatever material you used as a sub-base for the walkway, and use a good steep broom, sweep the sand / dust back and forth and diagonally over the pavers forcing as much material down into the joints as they will accept. Many contractors will also soak the dust when using stone dust, so that it settles even more tightly into the joints. Compactor must now run back and forth over the entire surface of the walkway. Not only will the compactor settle the sand / dust into the joints, it also pushes the pavers down into the sub-base and locks them in. During this process using some hearing aid, because it will be very, very loud.